BH EASY motion STAND UP Manuel De L'utilisateur page 47

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

STAND UP is provided with an integrated recharging system to the vehicle with
an external plug in the front part (Figure 13) directly to the system which is
retractable. On the rear part of the Central covering (Figure 14) there is a
switch to connect the charger and two informative light led to know the level of
the charge. This easy to charge the battery to any place without needing any
external charger. In this way, the charger system is always ready without
problems.
UTILIZATION OF THE SYSTEM
STEPS TO FOLLOW TO CHARGE THE BATTERY PROPELY:
1. Make sure the contact key to be in position "OFF".
2. Connect the plug to the electric system.
3. To initiate the charge, push the Red button from the rear side of the covering.
4. The light leds indicate the position level of the charge.
5. To stop the charging, push again the Red button
6. Take out the plug from the electric system
MEANING OF THE LIGHTS ( LEDS ):
-
RED LED: The charger is connected to the electric system
-
YELLOW LED : The charge is being charged (Figure 16)
-
GREEN LED: The battery is already charged (Figure 17)
-
OFF LED: The charger is disconnected (Figure 18)
ATTENTIÓN: The charger is equipped with a safety fuse of 25A, in
case that the chager it not work, check it not workk charger did not work,
check the state of the fuse and change it if it were necessary

Publicité

Table des Matières
loading

Table des Matières