Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2.1 Description of the remote control screen
1
Ambient temperature
2
Communication with the device
3
Warning, problem
4
Battery (replace batteries)
5
Manual mode
6
Programming Mode
7
Comfort Mode, Comfort –1°C, Comfort –2°C
8
Eco Mode
9
Frost Free Mode
Device off
ECO temperature display
COMFORT temperature display
Mode selection button
± buttons for adjusting COMFORT setting
± buttons for adjusting ECO setting
Note:
The remote control is supplied with its support which you can mount
on the wall using 2 screws.
Do not mount the support above the heater nor near to a heat source,
otherwise the ambient temperature display may give a false reading.
2.2 Screen on stand-by
Once the batteries have been correctly inserted into the unit, the remote control is on stand-by.
The screen is off.
2.3 Displaying the ambient temperature
The remote control is activated by pressing a button. The ambient temperature is displayed at the top of the screen. If
the settings are not altered, the screen switches itself off after 60 seconds and the remote control is once again on
stand-by.
2.4 Displaying the device configuration
When the ambient temperature is displayed, press a button again. The remote control retrieves the device's configuration.
The o))) symbol flashes while it is searching.
The configuration is displayed on the screen when it has been retrieved.
The display varies depending on the unit configuration:
hand displayed only
Manual mode:
an arrow is displayed opposite a sun (comfort) or a moon (eco). The COMFORT or ECO
Comfort or Eco mode:
settings can then be altered using the ± buttons (
Programming mode:
an arrow opposite the clock is displayed with another arrow opposite the programmed mode
(
display depends on the programmed mode.
an arrow opposite a snowflake is displayed with a bar under the ECO and COMFORT
Frost Free Mode:
settings
Off:
only an arrow opposite the symbol is displayed.
If the remote control fails to retrieve the device's configuration, the problem is notified as below.
is displayed: - stand opposite the device
- direct the remote control correctly towards the device's infrared cell
2.5 Changing the configuration
The user can alter the device's configuration when it is displayed on the screen.
- Press the mode button
to change the displayed mode.
- Press button
to change the Comfort setting (varies in 0.5° intervals).
- Press button
to change the Eco setting (varies in 0.5° intervals).
9 9 9 9 9
,
,
for comfort, comfort - 1 and comfort -2, or
1
2
3
4
5
6
7
8
9
9 9 9 9 9
,
).
, or
, or
). The rest of the
8 8 8 8 8
Publicité
Table des Matières
