10.1
Switching on and off
▪
Press the lock-off button (1) and squeeze the ON/OFF switch (2) to start the trimmer.
▪
To switch the appliance off, release the on/off switch.
CAUTION! After switching off, the nylon line will continue to rotate for a few
more seconds.
10.2
Replacement of the spool and line (Fig. 12)
▪
Press the sides of the spool cover and remove the cover
▪
Remove the empty line spool.
▪
Thread the ends of the line on the new line spool through the eyelets in the spool
receptacle.
▪
Fit the spool cover back in the spool holder.
▪
When you start the equipment again the line will be cut to the perfect length automatically.
CAUTION! Under no circumstances wind extra line on the empty spool but
instead replace it with a new one, the same as the original. The use of line
with different characteristics to those of the original can permanently
damage the grass trimmer as well as annulling the terms of the guarantee.
10.3
Manually thread lengthening
▪
The wire can also be lengthened manually if necessary.
▪
Before manually lengthen the wire, remove the battery from the device.
▪
Press the button on the manual extension wire and release it while pulling gently the wire
until it arrives at the cutter.
▪
The wire is too long if it exceeds the level of the cutter.
11 CLEANING AND MAINTENANCE
Your tool has been designed to operate over a long period of time with a minimum of
maintenance. Continuous satisfactory operation depends upon proper tool care and regular
cleaning.
▪
Regularly clean the ventilation slot in your tool using a soft brush or dry cloth.
▪
Regularly clean the cutting line and spool using a soft brush or dry cloth.
▪
Regularly use a blunt scraper to remove grass and dirt from the underneath of the guard.
12 STORAGE
▪
Store the trimmer out of reach of children, in a stable and safe position and in a dry place
where the temperature is not too hot or too cold.
▪
Store the trimmer away from direct sunlight, if possible in a dark or barely lit place.
▪
Do not store in a nylon bag because this could encourage the formation of damp patches.
▪
Do not store the grass trimmer resting on the floor. Hang it by the handgrip instead, so that
the guard does not touch anything. The resting of the guard on a surface could alter its
shape and therefore its dimensions and its safety characteristics would be modified.
Copyright © 2020 VARO
POWDPG75410
P a g e
| 10
EN
www.varo.com