Installation Of The Guide Wheel; Setting The Auxiliary Handle (Fig. 9); Adjustment The Cutting Angle (Fig. 10); Trimming And Edging (Fig. 11) - VARO Powerplus POWDPG7561 Utilisation Et Entretien

9.4

Installation of the guide wheel

When in edging mode, the guide wheel (11) needs to be installed on the trimmer. Insert the
guide wheel into the black slot piece of the motor housing (Fig 7). Make sure the guide wheel
is firmly connected with the slot and push the protector to make it not protrude (Fig. 8).
9.5

Setting the auxiliary handle (Fig. 9)

▪
Push the adjustment knob (4) tightly and turn the handle in a downwards direction. Push
the auxiliary handle down until the desired angle is set. Afterword's release the adjustment
knob.
9.6

Adjustment the cutting angle (Fig. 10)

Your Trimmers has a 4-positions cutting head. This setting allows you to work effectively at a
comfortable working angle. It can cut accurately around the flower beds, under bushes, around
trees and fence posts etc.
To change the angle, simply press the cutting head and move the shaft to the desired position.
9.7

Trimming and edging (Fig. 11)

The machine is designed to offer both a trimming and an edging function. To switch from
trimming to edging, press the function switch (7) on the tool, and firmly holding the telescopic
shaft in one hand and turn to left.
Warning: remove the battery pack from the trimmers before handling setting.
Warning: Always wear safety glasses. Never lean over the cutting head.
Stones or debris can bounce or be thrown into eyes and face and blind you
or serious injury. To use the machine, note the following points: Put on heavy
clothing and eye protection. Hold the front handle with one hand and the
auxiliary handle with the other hand. Store unit below the waist level. Have
the unit from right to the left so that residues are always projected on the
side opposite you. While avoiding bending over, keep the section parallel to
the ground wire (or perpendicular to trim edges) and prepared the material
to be cut (but not touching).
Warning: Before starting work, make sure that the wire is long enough. Do
not start work before the engine running at full speed.

10 OPERATION

If the line is too long when you use the equipment for the first time, the
surplus end of it will be cut by the blade on the guard hood.
Your grass trimmer will work at its best if you observe the following instructions:
▪
Never use the grass trimmer without its safety devices.
▪
Do not cut grass when it is wet. The best results are had on dry grass.
▪
Do not move the grass trimmer against the grass until the switch is pressed, i.e. wait until
the trimmer is running.
▪
For the correct cutting action, swing the grass trimmer to the side as you walk forward,
holding it at an angle of approx. 30° as you do so.
▪
Make several passes to cut long grass shorter step by step from the top.
▪
Use the edge guide and the guard hood to prevent unnecessary wear on the line.
▪
Keep the grass trimmer away from hard objects in order to avoid unnecessary line wear.
Copyright © 2020 VARO
POWDPG75410
P a g e | 9
EN
www.varo.com