Maintenance And Inspection - Kyocera TJEP 9/20 HP Mode D'emploi

UK
• If use is continued as is, it may cause an accident.
18. Before moving the product make sure that:
• the operation is stopped.
• all the compressed air has been released from the air tank.
• all the parts have sufficiently cooled down. Failure to comply may cause burn
injuries or accidents.
• the power plug is disconnected from the power source.
1. Do not sit or stand on this product or place objects on it. (It may cause damage, cracks or
deformation)
2. The compressor is for AIR application only. Do not use the product to compress or
separate gas other than air. (Doing so may cause fire or damage the device.)
3. After deactivating the product with the start/stop switch, wait at least 5 seconds before
restarting. (Otherwise it may fail to start up.)

3.2. Maintenance and inspection

1. When performing maintenance or inspection, be sure to press the stop/start switch to stop
the unit, and after confirming that the operation display LED is flashing, remove the power
plug from the power source.
2. Latest 3 years after purchase or if the maintenance period notification display LED is
flashing, contact the dealer where the product was purchased or call the service number
shown on the sticker which is placed on the compressor to have maintenance (an over-
haul) carried out.
3. Unauthorized disassembly or repair of the product and parts is extremely dangerous.
Never do this.
• If someone other than a professional repair technician carries out disassembly
or repairs, not only will the product not display sufficient performance, it may also
cause breakdown or an accident.
4. Check thoroughly that the product and air tank have no damage, cracks or deformation. If
there is any deformation or damage to the handle, air tank or control box, immediately halt
use and contact the dealer or call the service number.
5. Never carry out repairs or alterations to leaks in the air tank.
• If there is damage, crack or deformation, it may cause personal injury.
6. Be careful that dirt and dust do not build up in the power outlet or plug, and clean
regularly.
• Regularly check the power outlet and plug, and remove dust with a dry cloth. If you
find deformation or discoloration, consult the nearest electrician.
12
CAUTION
WARNING