Preparations Before Operation - Kyocera TJEP 9/20 HP Mode D'emploi

UK
• The equipment is not suitable for stationary
use.
• When not in use or carrying out mainte-
nance/inspection, be sure to press the
stop/ start switch to stop the unit, and after
confirming that the operation display LED is
flashing, disconnect the plug from the power
outlet.
• If the plug is removed from the power
source while the operation display LED is
on, the power failure automatic recovery
function kicks in. Consequently, when
the power is re-connected, the compres-
sor automatically begins operation which
may lead to unexpected accidents.
When operating the product, the ambient
temperature should be 5 - 40°C
Prohibited
Failure to comply may reduce product-lifespan, or may
cause the electric motor to burn out or operation of the
product to fail.

3.1. Preparations before operation

1. Do not put thin and long objects such as fingers or nails into openings. (Entanglement
may cause a breakdown or accident.)
2. If the product is accidentally dropped or banged, check carefully that there is no damage,
crack or deformation to the product or air tank. If there is any damage, crack or deforma-
tion, it may cause an accident.
3. If there is any deformation or damage to the handle, air tank or control box, immediately
halt use and contact the dealer where it was purchased or call the number written on the
service label.
10
Important notes
CAUTION
Do not use in an atmosphere containing
corrosive gases such as ammonia, acids,
salts, ozone gas or
sulphuric acid gas.
Prohibited
Failure to comply may cause the whole product to rust or
reduce the product-lifespan.
WARNING
Always unplug
when not in use.
Prohibited