Fixing With Screws - ADEUNIS sigfox TEMP Guide D'utilisateur

sigfox TEMP- Guide utilisateur / User guide version V2.0.0
To optimise fastening onto a tube or mast, we recommend you
remove the Rail-DIN locking/unlocking lever.
To remove it, pull the lever down until the locking pins are opposite
a freed-up part and then remove the lever

6.2.2 Fixing with screws

The product is delivered with 2 CBLZ 2.2 x 19 mm screws and 2 SX4 wall plugs. Use these products or equivalent products in order to fasten
your product onto a flat support.
Two positions may be selected: Laid flat or on its edge.
• Placing it on its edge enables the product to be placed at a distance from its support and helps achieve better propagation of the radio
waves.
• If you opt for laying it flat, make sure you remove the Rail-DIN locking/unlocking lever, as explained above
49,50
Fastening laid flat
Location of the screws for
fastening it laid flat
Location of the screws for
fastening it on its edge
49,50
Fastening on its edge
Pins
Freed up part
FR
EN
49,50
Page 73 of 79