sigfox TEMP- Guide utilisateur / User guide version V2.0.0
3.4. Description of the registers
On switching on the product works according to the last saved configuration (Factory Configuration if it is the first start, or if this configuration
has not been changed). Commands such as Modification TTY<n>=<M> or ATR allow you to change the content of the registers: <n> repre-
senting the number of the register and <m> the value to be assigned. This latter is either a decimal value or a hexadecimal value consistent
with the «encoding» column of the tables below.
Examples:
• ATS300=6 assigns the decimal value 6 in register 300
• ATS320=2 assigns the hexadecimal value 0x02 in register 320
It is imperative to save the parameters with the command AT&W before exiting the Command mode otherwise all changes will be lost.
3.4.1 Function registers
The list of registers below allows you to change the behaviour of the product application.
Register
Size
Description
(bytes)
300
1
Transmission period of the Keep Alive
frame
301
1
Transmission period of data sensors
304
2
PIN code
306
1
Global operation
307
.2
Number of downling frame per day
320
1
Configuration of the internal sensor
Coding
Details
Decimal
Default: 144
Min/max: 1 à 255
Unit:
x 10min if S306=1
x 20s if S306=2
Decimal
Default: 1
Min/max: 0 à 255
Unit:
x 10min if S306=1
x 20s if S306=2
The value 0 means no periodic sending, therefore event
operation
Decimal
Default : 0 (disabled)
Min/max : 0 to 9999
PIN code used with ATPIN command.
Value 0 disables the PIN code.
IMPORTANT: The product does not have a mechanism to
unlock the PIN code if it is activated and the code is forgot-
ten.
Decimal
Default: 0
Allows the product to be switched into one of the following
modes:
• 0: PARK mode
• 1: Production mode
• 2: TEST mode
• 3: REPLI mode
Decimal
Default: 0
Min/Max: 0 to 4
Unit: none
See detail paragraph 4.2
Hexadecimal Default: 0x00
Bits 0 to 3: Reserved
Bits 4 to 7: Identifier (free to use)
FR
EN
Page
59
of 79