Dremel VRT1 Consignes De Sécurité/D'utilisation page 15

Cutting guide should be attached when using
Drywall, Tile, and Spiral cutting bits according
to assembly instructions.
Drywall Cutting Bit
Gives you fast, clean cuts in drywall.
Tile Cutting Bit
Cuts ceramic wall tile, cement board, and plaster.
Spiral Cutting Bit
Cuts through all types of wood and wood
composites.
Replacing Screw Mandrel
Accessories
Mandrel No. 401 is used with the felt polishing
tip and wheels. Thread the tip on to the screw
carefully. The felt tip must thread down straight
on the screw Mandrel, and be turned all the way
to the collar.
15
Mandrel N° 402 has a small screw at its tip, and
is used with sanding discs. Higher speeds,
usually maximum, are best for most work.
To replace a band on the Drum Sander, loosen
the screw without removing it to contract the drum
then slide the old band off. Slide the new sanding
band on and then expand the drum by tightening
the screw once again.
Before each use, check to
make certain
components are assembled to accessory WARNING
shank and that the drum is sufficiently
expanded to secure the band during use. If
sanding band is loose on the drum during
operation it may "fly" off and strike you or
bystanders.
that all