common, but it does happen.
Practice on scrap materials first to see how the
Rotary Tool's high speed action performs. Keep in
mind that the work is done by the speed of the tool
and by the accessory in the collet. You should not
lean on or push the tool during use.
Instead, lower the spinning accessory lightly to the
work and allow it to touch the point at which you
want cutting (or sanding or etching, etc.) to begin.
Con centrate on guiding the tool over the work
using very little pressure from your hand. Allow the
accessory to do the work.
Usually, it is best to make a series of passes with
the tool rather than attempt to do all the work in
one pass. To make a cut, for example, pass the
tool back and forth over the work, much as you
would a small paint brush. Cut a little material on
each pass until you reach the desired depth. For
most work, the gentle touch is best. With it, you
have the best control, are less likely to make
errors, and will get the most effi cient work out of
the accessory.
Operation
Do not use on material that
generate sparks. Spark may
WARNING
cause fire or explosion in the vacuum.
Turning the tool On and Off
Always check to make sure the
tool ON/OFF switch is at the
WARNING
"O" position before plugging tool to vacuum
hose. Accidental start-ups could cause injury.
To turn tool on:
1. With wet/dry vacuum ON.
2. Grip body of tool and ON/OFF Ring.
3. Rotate ON/OFF Ring counterclockwise (Fig. 6).
4. Variable speed can be achieved by partially
opening ON/OFF Ring.
To turn tool off:
1. Rotate ON/OFF Ring clockwise (Fig. 7).
2. Turn wet/dry vacuum OFF.
11
FIG. 6
"ON"
FIG. 7
"OFF"