Tandem Axle (Optional) - Woods BW15.70E Manuel De L'utilisateur

Tandem Axle Installation
1. Raise unit and support with jack stands per diagram
page 20 to take pressure from tires.
2. Remove wheel assembly from right spring arm hub
assembly from center frame.
3. Remove axle hub from right spring arm.
4. Install drive type grease fitting in four holes in spring
arm.
5. Install tandem arm 1045738 as shown.
6. Install tandem arm 1045739 as shown, sliding both
axles into receiving tubes. Fasten with screws 3489
and nuts 1045624 provided.
7. Install axle/hub 1017050 and secure with screw3489
and nut 1045624,reused or purchased separately as
needed.
8. Install wheel assembly.
9. Repeat for left spring arm of center frame, using
1045850 in place of 1045738, installed from the
center.
10. Repeat for wings if purchased, noting orientation of
parts to locate wheels in the correct position. Outer
wheel should be forward of inner wheel on both wings.
MAN1258 (3/26/2018)

TANDEM AXLE (OPTIONAL)

REF
1
2
3
4
5
6
PART QTY
3489 8 HHCS 1/2 NC X 3 GR5 ZP
1043432 8 ZERK, 1/4 DRIVE TYPE
1045624 8 NUT, HFN 1/2 NC, DRI-LOC PATCH
1045738 1 WA, TANDEM ARM, RT
1045739 1 WA, TANDEM ARM, LT
1045850 2 WA, TANDEM ARM
Parts 49
DESCRIPTION