Loading Files From The Tftp Server - Sagem Fax ATA 101S Livret Utilisateur

Sagem_Fax_ATA101S.book Page 10 Jeudi, 21. février 2008 5:09 17
For example, for the ATA with a MAC address 00:60:4c:99:99:99
there is a corresponding file "Sagem_00604c999999.txt", the content
of which (below) specifies the settings of the SIP account (user name,
password, etc.) likely to be used with this ATA:
MACConfigversion = V1_01
sip/configphone 1 444719 -o -d Lecoq
sip/configauth 1 444719 MySecretPassword
save
sip/register all
These CLI command files must be in ASCII format.
To create these ASCII files, contact Sagem
Communications or your dealer to obtain the ATA's
list of CLI commands.

Loading files from the TFTP server

After creating the command files, you have to connect the ATAs to
your company's computer network. For this purpose, you have to use
your ATA "WAN" port. Indeed, only this port has a DHCP client
allowing the ATA to request an IP address from the DHCP server and
also to receive the address from the TFTP server and the input
filename. These must be defined at the DHCP server end, as options
66 and 67 respectively.
Make sure not to use the ATA LAN port for the
"automatic setup" mode, as you will encounter IP
address conflicts.
As soon as it is connected to the network, each ATA automatically
downloads the input file. If this file specifies a new firmware, this
firmware is then downloaded. If not, the ATA downloads its two setup
files (the common file then the customized file) to run their CLI
commands.
10
Note
Important
Sagem Fax ATA 101S