Preparing The Appliance - British Fires NEW FOREST ELECTRIC Guide D'installation Et Mode D'emploi

//

8.0 PREPARING THE APPLIANCE

ALTERING THE CORNER BRACKET POSITION
Putting the corner gland bracket together
Secure the corner gland bracker as picutred below
1 2
Different corner bracket orientations
Select which orientation the power cable would suit the installation best.
// ATTENTION:
Corner brackets can be found in the styrofoam cap.
Blanking plates and trims are located attached below to the base styrofoam in the packaging carton.
// 07
Removing the corner bracket
Remove the three (3x) screws holding the corner
bracket into position on the rear right hand side
of the appliance with a cross headed screw driver.
3
Crosshead screws
Reinstalling the corner bracket
Once the preferred position has been selected,
screw the three (3x) screws back into position,
securing the corner bracket into place.
Crosshead screws
// 8.0 PREPARING THE APPLIANCE
ADDING BLANKING PLATES AND TRIMS; REMOVING FRONT GLASS
Twelve (12) firebox screws can be found packaged in the top styrofoam casing and the blanking plates and trims can found underneath the base of the Styrofoam.
Front-Facing (One-sided)
Firebox screws
A blanking plate will need to be installed at each
end of the appliance, offer the blanking plate up to
the side of the appliance and ensure that all of the
holes in the blanking plate line up with the holes
on the side of the firebox. Once in the correct
position, screw the 6x firebox screws with a cross
Blanking Plate
headed screw driver into position, use the same
process for both sides.
Cornered (Two-sided)
Install only one of the blanking plates on the end that
will be covered. Follow the front-facing instructions,
above, for the one blanking plate. For the exposed
side the trims will need to be used. Place both
small trims into position, lining the screw holes up,
then when in the correct position screw into place
with the screws provided using a cross headed
screwdriver. Next, secure in place the large trim
vertically on to the side of the appliance in between
the two small trims. Line the screw holes up and
secure the provided screws into place with a cross
headed screwdriver.
Fully-inset (Three-Sided)
Place both small trims into position, lining the screw
holes up then screw into place with the screws
provided using a cross headed screwdriver. Once the small trims are
installed the large trim will be vertically placed in between the two
small trims, as pictured above. Use the same steps for both sides.
© 2020 British Fires
We strongly recommend that two people are used
to remove the glass, both using protective gloves.
To remove the front glass from
the appliance, use a cross headed
screwdriver to remove the screws
from either end of the top bracket
of the appliance, holding the glass
in place.
Ensure the glass is supported at all times.
Next, gently leaver the top of the
glass towards you, ensuring you
have full support of the glass.
Lift the glass up and out from the
appliance and place the glass on
a soft, flat surface on the floor.
Small trim Insert your prefered fuel bed
options as shown in the following
pages in section 10.0 – 10.2.
Large trim
To re-install the glass, see the
instructions in reverse order.
Small trim
Crosshead screws
// 08