EZiclean turbo silence 400 Manuel Utilisateur page 14

EN
Cleaning device
1. Cleaning the machine
01. All routine maintenance and maintenance work should be performed after the vacuum plug is unplugged.
02. Always clean the garbage in the dust cup to avoid the vacuum cleaner malfunction.
03. The surface of the vacuum cleaner should not be scrubbed with gasoline or other oils. Please scrub
with water or a neutral detergent.
04. Do not leave the vacuum cleaner in a place exposed to direct sunlight or moisture when it is not in use.
ATTENTION : The rag should be wrung out during cleaning. Do not allow water to seep into the vacuum
cleaner.
2. Cleaning the floor brush
01. Turn off the power button (Refer to turn off the power, retract the power cord);
02. Remove the floor brush;
03. Rin off the hair, animal hair, or debris that is entangled on the brush head and remove dust;
04. Reinstall the floor brush back into the machine.
3. Cleaning dust tank
01. Turn off the power button
02. Remove the dust cup (Refer to page7)
03. Press the button of the dust cup bottom cover button, pull the button, open the dust cup bottom cover,
and pour the dust.
4. Cleaning filter
This product is equipped with the following filter
01. Cyclone filter----installed inside the dust cup to separate and filter dust and hair.
Cleaning cycle: Generally, it should be cleaned at least once a month. Be sure to use it after drying.
02. Air intake filter sponge----lnstalled on the air intake filter to filter fine dust.
Cleaning cycle: Generally clean at least once every two months. Be sure to use it after drying.
03. Square filter sponge----installed at the rear end of the upper air duct, the upper part of the air intake
of the motor.
Cleaning cycle: Generally clean at least once every four months. Be sure to use it after drying.
04. Outlet HEPA filtration----filtering at the back of the machine to ensure clean air.
Cleaning cycle: Generally clean up once every six months. Can be beaten or washed. Be sure to use it
after drying.