Publicité
Les langues disponibles
Les langues disponibles
POSIBLE CAUSES OF A MONOBLOC MALFUNCTION
Cause
Dirty filtering media
The pump sucks air (bubbles in the aspiration)
The water level of the skimmer is low.
The skimmer basket has moved.
The basket of the pump pre-filter has moved.
In case of finding problems not mentioned above, please consult your usual salesperson.
WINTERING
At the end of the summer season, disconnect the tubes; remove water from the
filter by opening the tap.
For the filter and the pump, you have to undo the purge screw.
Open the filter and check the sand, Check the state of the sand in the monoblock.
It must not be sticky or stuck together) and clean it.
The monoblock placed in the open air must be protected against freezing during
the winter.
Damage caused by freezing is not covered by the guarantee.
MAINTENANCE SUGGESTIONS
Warning
The filtering kit is not compatible with a salt treatment of the pool.
The visible impurities are eliminated by the monoblock. What the monoblock does
not eliminate are the algae, bacteria and other microorganisms that cloud the
water, affect the water purity and hygiene. To prevent their appearance and
eliminate them, specific products exist for the water maintenance, with a correct
dose do not cause any problems to the bathers guaranteeing a pool perfectly
disinfected.
The filtration cycles as well as the use of the pool floor cleaner,
are the necessary conditions for the good maintenance of your
pool.
Ask your dealer for advice.
TRIGANO JARDIN
Le Boulay 41170 CORMENON
TEL : 02 54 73 55 82
http://www.triganojardin.com/sav
Solution
Carry out a Counterwash (Wash the sand)
The hosepipe could be defective. Tighten the
clips
Check the level and raise it if necessary.
Clean the basket and replace it correctly.
Clean the pre-filter basket and replace it.
17
Publicité
