Publicité
Les langues disponibles
Les langues disponibles
FILTER PARTS INSTALLATION
1.
Insert the tube with the manifold into the container (drawing 2) and screw the
small sand guard filters to the manifold (drawing 3).
2.
Place the completed manifold on the foundation and fill halfway with water to
stabilize it. Make sure that the star-shaped gauze is well centralized in the
bottom of the filter and that the purge screw is tight.
3. Place the spigot on the mouth of the container, making sure the tube is
centred on the manifold.
4. Fill the filter tank with your filtrering media (if not pre-installed):
•
Aqualoon filtering ball: see capacity depending on your filter
•
Sand: approx. ¾ in height. (Ideal sand grain size: 0.7 – 1.2 mm;
capacity depending on your filter) (drawing 4).
5. Place the gasket under the valve. Place the valve over the filter tank while
pressing it over the tube with manifold. Then install the closing flange.
(drawing 7 and 8)
6. Put the pieces to connect the filter to the valve. Make the joints watertight
with PTFE tape. Be aware of the wrapping direction of the tape (same as
screwing direction).
7. Install the valve pump hose with the closing flanges provided.
drawing 1
drawing 2
drawing 3
12
Publicité
