Programming; Formatting Programming Strings; Enter Reporting Number - Electrolux ControlBox 24/7 Manuel D'utilisation

PROGRAMMING

Formatting programming strings

All commands to the unit must be given in capital letters. It is therefore important that you use CAPITALS when sending
commands to the unit. Formulate commands to the unit as follows:
<COMMAND> + <space> + <VALUE>
Examples of all commands are given later in this manual.
The unit will always acknowledge a successful command with "Confirmed: <STATED COMMAND STRING>" so that you know
that the command has been correctly given and executed.
If an incorrect command is sent to the unit, it will automatically forward the message to the primary reporting number
(TEL1) with the following prefix: "Unknown command".

Enter reporting number

To enable the unit to know which status reports to send, one or more numbers must be entered. Up to 5 different
numbers can be entered for receiving status reports.
To save a number as the unit's primary reporting number (TEL1) send the following text message to ControlBox24/7;
TEL1 <NUMBER>
To enter more report recipients, replace TEL1 with TEL2, TEL3, TEL4 or TEL5.
To delete a registered report number, replace the telephone number with DEL as follows:
TELx DEL
The primary reporting number TEL1 differs from the others as follows: if an unknown or
incorrect command is sent to to the unit, it will be automatically forwarded to the number
saved as TEL1.
Example: TEL1 070765874
Example: TEL2 DEL
8
TIP! If you send TEL? to
ControlBox24/7, you will
receive a list of all telephone
numbers stored in return.