TechniSat TECHNIMAX SR1 Guide De Démarrage Rapide page 32

After the connection has failed 3 times, you can connect via
WiFi. Tap Start when prompted.
A window will appear with the name of the WiFi access
point for your TECHNIMAX SR1.
Tap the name.
Then you need to scan the QR code, which is located on the
bottom underneath the dust bin.
Subsequently, a list is shown of the WiFi networks within
reach. Select your WiFi network and enter the password for
your WiFi network. The TECHNIMAX SR1 now connects to
your WiFi network and the WiFi icon lights up permanently.
32
If not already done, switch the TECHNIMAX SR1 on with the mains switch and wait until
it is completely ready for operation.
Press and hold the HOME and START/STOP buttons on the top for at least 3 seconds
until a beep sounds and the WiFi icon flashes.
Then tap the Next button.
If the connection fails, please pay attention to the following points:
- Turn the robot off and on again.
- Wait until the red symbol lights on the robot turn off.
- Press the two buttons on the robot again for 3 seconds.
- Make sure the robot is no more than 2 meters away.
If the connection still does not work, you will be asked to configure the connection via
WiFi.