MIA Power Steam Electronic Mode D'emploi page 13

"Standby-mode" automatically then (see fig. 4) „Standby" is a safety function to avoid burn and
damage of the textiles if the iron will be left parked in vertical position and will not be moved any
more for a longer time. The iron indicates this with an acoustic signal and the word „Standby" will
appear on the display. As soon as the iron will be moved again, it will change into the preset
adjustment. The red control lamp is switched off and the blue control lamp is illuminated. Then
preset adjustment is indicated in the display again.
If the iron is positioned upright for a longer time, it will change into „Standby" mode after approx.
20-30 minutes. The red control lamp will flash permanently then.
Temperature adjustment and indication
Always check first to see whether a label with ironing instruction is attached to the article to be
ironed.
Synthetic fibres, Acryl, Viscose, Polyamide, Polyester (low temperature, see fig.1)

 silk, wool (medium temperature)
 cotton, linen (high temperature, see fig. 3)
MAX highest temperature setting for thick cotton or linen fabrics
The appliance provides a 4-level temperature adjustment with blue illuminated LED indication on
top of the handle. The desired temperature can be adjusted by pressing the temperature control
(see fig. 1). The levels from 1-4 (= MAX) are indicated as soon as the temperature control will be
pressed. Press 1 x = low level , press 2 x =  next higher level etc. Each time you press the
temperature control an acoustic signal will sound.
The selected operation mode is indicated by various symbols in the display (see the pictures 1-4
in the following instruction also).
While heating up a thermometer picture will appear on the right side next to the temperature
indication (see Fig. 2 and 3). It indicates that the appliance is heating up until the appliance has
reached the adjusted temperature. Then it will switch off.
Fig. 1
Steam control
Fig. 3
Burst of steam
button
Spray button
Ironing without steam
Before starting ironing always check first whether a label with iron symbol is attached in the
reverse side of the cloth. See the table provided in these instructions for choosing the right
ironing level. Follow these ironing instructions in all cases. Start ironing by using textiles which
need low iron temperature like synthetics, silk. Ensure that steam control is in position "0" (Fig. 1,
"Steam off"). Tip: Sensitive fabrics tend to get glossy stripes or water spots while using steam.
When steam-ironing woollen fabrics, shining of the fabric may occur. This can be prevented by
turning the article inside out and ironing the reverse side. Iron all sensitive fabrics by turning them
to the reverse side first. To avoid risks completely do not use steam while ironing sensitive
fabrics.
Temparature control
Self cleaning button
13
Fig. 2
Fig. 4