Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
S
c
o
p
e
o
f
d
e
l
i
v
e
S
c
o
p
e
o
f
d
e
l
i
v
e
Steam iron
•
Filling cup
•
Instructions for use
•
Warranty card
•
B
e
f
o
r
e
f
i
r
s
t
u
s
e
B
e
f
o
r
e
f
i
r
s
t
u
s
e
Remove all plastic bags, stickers and the protection film from the sole plate.
•
Unroll the cord completely.
•
Clean the cold sole plate with a soft damp cloth.
•
Some parts of the iron have been slightly greased during production and as a result may
•
smoke slightly for a short time when switched on for the first time. This will stop after a while.
H
o
w
t
o
u
s
e
a
n
d
H
o
w
t
o
u
s
e
a
n
d
Warning! Danger of serious burns! Never touch the hot sole plate!
Caution! Danger of electrical shock! Always fill in water before you plug in. Take care that
water does not run over the appliance and can intrude into the electrical parts of the
appliance because it could cause short circuit and danger of life by electrical shock.
Filling water
Before filling water, unplug the appliance first. Set the steam control to
the "0" position (see picture).Open the cover of water tank
and fill in water. (In areas with very calcareous water, distilled water can
prolong the lifetime of the iron). Close the cover of the water tank again.
Switching on
Caution! Never leave the appliance unattended while in operation.
Caution! Danger of serious burns! The sole of the appliance gets hot during operation.
During operation of electrical caloric appliances, high temperatures caused by hot sole or
hot steam are generated, which may cause injuries. Only touch the handle! Never touch
any hot parts!
Connect the plug into the mains. As soon as the appliance is connected to the mains supply the
control lamps illuminate (on the right side of the back and on the handle on top) and indicate, that
the appliance is in operation. All indications will appear in the display for some seconds, then the
appliance will switch into a neutral function automatically. „OFF" is indicated in the display (see
picture above).
Functions of the control lamps
The blue control lamp (on the right side of the back) indicates operation and that the appliance
is connected to the mains supply. The blue control lamp is illuminated during ironing also.
The red control lamp is illuminated while heating up and will switch off as soon as the
temperature is reached.
The blue control lamp will switch off for a short time and the red control lamp will switch on for a
short time, if the appliance is in upright position and the operation mode will be changed by
switching into another level.
After two minutes the blue control lamp will switch off and the red control lamp switches on and
flashes, while the appliance is standing vertically on the working place, it will switch into a
r
y
r
y
t
i
p
s
t
i
p
s
Steam control
12
Publicité
Chapitres
Table des Matières
