MIA Power Steam Electronic Mode D'emploi page 11

never touch the appliance with wet hands or standing on wet ground
-
never place the appliance on wet ground
-
in bathrooms or humid rooms always switch off and unplug electric appliances after
-
use. The proximity of water presents a hazard even when switched off!!
never use the appliance outdoors, it is not suited for outdoor use.
-
Unplug the appliance
•
when the appliance is not in use
-
before cleaning accessories or the appliance
-
when malfunctioning during use
-
To unplug only pull the plug, never pull on the cord to avoid damage.
•
Never move the appliance by pulling the cord. Make sure the cord cannot get caught in any way.
•
This can avoid accidents of falling down and risk of burning by hot parts of the unit.
Do not wind the cord around the appliance and do not bend it.
•
From time to time check if the cord is damaged. In this case or if the appliance is damaged
•
it must not be used any more.
Before first use ensure that your mains voltage corresponds to that stated on the rating plate of
•
the appliance.
Connect this appliance to a plug which is wired according to the regulations (230 V ~AC).
•
Place the appliance on a dry, stable, ant-slip and heat resistant surface.
•
Never place the appliance on to or near a hotplate or a hot oven or any other heating
•
element to avoid damage.
Never store it near a heating element, plastic parts of the housing could melt.
•
Run the cable in a way that nobody can stumble over it or pull on it to avoid accidents.
•
Take care that the cable never comes into contact with sharp edges and hot objects.
•
• Additional protection may be obtained by fitting a residual current device that must not exceed
30 mA (IF < 30mA,) into your home installation. Please consult a qualified electrician.
Never leave the appliance unattended during operation.
•
Always watch the appliance during operation. After each use, unplug.
•
Danger of burning! The sole of the appliance gets hot during operation. During
•
operation of electrical caloric appliances, high temperatures – by hot air or hot sole – are
generated, which may cause injuries. Only touch the handle! Never touch hot parts!
Do not fold the cable or wind it round the unit to avoid damage.
•
Let the unit cool down completely before cleaning and storing.
•
Caution! Always keep enough distance to heat sensitive surface, or furniture. Do not place
•
the iron on any heat sensitive surface while it is hot.
Ensure that the cord does not touch hot elements nearby or hot parts of the appliance like sole.
•
Note: Never use the appliance outside and always place it in a dry environment.
•
The appliance is not suited for outside use. Moisture can damage the appliance.
Do not use this appliance for other purpose as for ironing.
•
Keep the device and the cable always away from heat, direct sunlight, moisture, sharp
•
edges and suchlike dangers.
Switch off the device whenever you are not using it, even for a short moment.
•
When you have finished ironing, or when leaving the iron unattended (even for a
•
short while), when you clean the appliance or when filling or emptying the water
reservoir:
− Set the steam control to position to 0 (Off),
− Place the iron in vertical position
− Remove the mains plug from the wall socket.
11