Klarstein VICTORIA 60 Mode D'emploi page 29

Mark Points
Note: The specified values are [mm].
(1) Mark a point (1) on the horizontal line A, 80 mm to the right of the vertical
reference line. Repeat this operation on the other side and on the vertical reference
line, checking that the three marks are leveled.
(2) Mark a point (2) on the horizontal line B, 40 mm to the right of the vertical
reference line. Repeat this operation on the other side , checking that the two marks
are leveled.
(3) Mark a point (3) on the horizontal line C, 170 mm to the right of the vertical
reference line (Solution 2). Repeat this operation on the other side , checking that
the two marks are leveled.
Fix the brackets (optional)
• Drill at the marked points (1), (2), (3), using a 10 mm drill bit.
• Insert the Wall Plugs into the holes (1), (2), (3).
• Fix the hood fixing bracket with 3 screws (5 x 50) at the horizontal line A.
• Fix the Chimney fixing bracket with 2 screws (5 x 50) at the horizontal line B.
Hook the hood body
• Hook the hood body to the bracket.
• Level the hood body itself.
• Remove the filter from the inside of the hood body, fix the screws to Wall Plugs at
the points (3).
Right Wrong
EN
29