AVS Electronics BM60HP Mode D'emploi page 60

"False Alarm" library customisation
It is possible to create a waveforms customised archive to modulate the reply of the barrier
depending on the environmental contexts.
The signals transferred in the archive called "False Alarm", are verified by the microprocessor
before activating the real and proper alarm signal. If there were a correspondence between the
recorded signal and the generated waveform, the barrier will not activate any signal, considering
the event a false alarm.
We recommend setting in this archive only the ascertained false alarm signals.
Procedure:
1- Click on "False Alarm"; it will be requested to confirm the operation.
2- Press Yes to confirm; the wording "sample added to the library with success" confirms the
operation. If the procedure is rejected, it means that signal is not recognised among those that
can be customised.
3- Press No to desert the procedure
E
N
G
"Alarm" library customisation
This library is linked to the detection mode of the barrier.
The barrier checks this archive when the barrier is set in "ALARM IDENTIFY" detection mode;
the barrier will be alarmed only if the detected signal coincides with one of those recorded in this
archive.
Procedure:
1- Click on "Alarm"; it will be requested to confirm the operation.
2- Press Yes to confirm; the wording "sample added to the library with success" confirms the
operation.
3- Press No to desert the procedure
- 60 -