AVS Electronics BM60HP Mode D'emploi page 56

Sensitivity management
To obtain maximum possibility of managing the barrier settings, we recommend setting the
SENS trimmer on the receiver at halfway of its run.
This setting on the barrier allows the complete management of the sensitivity, even with connection
from PC.
The graphic displaying is had by checking the position of the RED line on the oscilloscope. The
closest the line to the upper part and, therefore, to the barrier signal (white line), the more sensitivity
increases.
The numerical indications (127 / - 127) indicate by how much, in percentage, the signal increases
or decreases, compared to the trimmer position adjusted in barrier.
The setting at (0) zero, displays the exact adjustment of the sensitivity on the barrier without any
influence by the management software.
E
N
G
Compensation management
To obtain maximum possibility of managing the barrier settings, we recommend setting
the COMP trimmer on the receiver at halfway of its run.
This setting on the barrier allows the complete management of the compensation, even with
connection from PC.
The "Compensation" value (xx) indicates that the alarm threshold line (Red line) rises by xx Volts
per second only when the microwave signal is disturbed enough to come out from the window
fixed by the two yellow and green lines.
The numerical indications (127 / - 127) indicate by how much compensation increases or
decreases, compared to the trimmer position adjusted in barrier.
The setting at (0) zero, displays the exact adjustment of the compensation on the barrier without
any influence by the management software.
Cursor position Compensation V/sec.
- 56 -
Hight Sensitivity
Middle Sensitivity
Low Sensitivity
Description
High compensation
intervention.
Average compensation
intervention.
Compensation does not
intervene.