Problems And Solutions; Possible Causes - Klarstein Barossa Mode D'emploi

EN
32

PROBLEMS AND SOLUTIONS

If the mains cable supplied is damaged, it must be replaced by the manufacturer, a
centre approved by the brand or by the retailer. In all cases, it must be replaced by
qualified personnel, so as to avoid any risk of injury.
If these checks reveal nothing, then contact your retailer's after-sales department.
CAUTION!: Unplug the appliance before carrying out any maintenance or repair work.
You can solve many simple problems with your wine cooler yourself, thus avoiding
having to contact your after- sales department. Try the following suggestions:
Problems
Appliance is not running
Appliance is not cold enough
The compressor starts
and stops frequently
LED lights do not operate
Vibration
The appliance makes
a lot of noise

Possible Causes

• Appliance is not plugged in
• Appliance is not turned on
• Check if voltage of the installation
• Check the circuit breaker or if fuse has blown.
• The external temperature is high.
• A large quantity of bottles has been put into
the cellar.
• The appliance is opened frequently.
The door is not properly closed.
• The cellar has not been correctly set.
• The appliance is not plugged in
• The fuse has blown
• LED lights are not broken
• The light switch is off.
• The appliance is not plugged in
• The fuse has blown
• LED lights are not broken
• The light switch is off.
Check and ensure that the appliance is level
• A noise resembling circulating water is
produced by the coolant gas and this is
normal.
• At the end of a cooling cycle, you can hear the
noise of water circulating.
• Expansion and contraction of the internal walls
may cause a cracking sound.
• The appliance is not level
• Check if fan is in good condition.