Atag KA2411R/A02 Notice D'utilisation page 23

What to do if...
Problem
The appliance does not oper-
ate.
The appliance is noisy.
A rectangular symbol is
shown instead of numbers
on the Temperature Display.
The lamp does not work.
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after press-
ing the IntensiveCooling, or
after changing the tempera-
ture.
Possible cause
The appliance is switched
off.
The mains plug is not con-
nected to the mains socket
correctly.
There is no voltage in the
mains socket.
The appliance is not sup-
ported properly.
Temperature sensor prob-
lem.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor-
rectly.
The IntensiveCooling func-
tion is switched on.
This is normal, no error has
occurred.
Solution
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
Check if the appliance stands
stable.
Contact the nearest Authorized
Service Centre (the cooling sys-
tem will continue to keep food
products cold, but temperature
adjustment will not be possi-
ble).
Close and open the door.
Contact the nearest Authorized
Service Centre.
Refer to "Operation" chapter.
Wait some hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
Refer to "IntensiveCooling func-
tion".
The compressor starts after a
period of time.
23