Clearances And Dimensions - Viking DrawerMicro VMOD241SS Instructions D'installation

CLEARANCES AND DIMENSIONS

• Dimensions that are shown in FIGURE 1 must be used.
Given dimensions provide minimum clearance. Locate
electrical outlet in the shaded area in the upper left-
hand corner of the cutout. See FIGURE 4.
• Contact surface must be solid and level. Pay special
attention to the floor on which the appliance will sit.
The floor of the opening should be constructed of
plywood strong enough to support the weight of the
oven (about 100 pounds).
DrawerMicro Oven MEASUREMENTS
Electrical outlet location
4"
22 "
opening
Allow ¾"
overlap.
23 ½"
min depth
36"
counter-
top
height
24"
cabinet min.
FIGURE 1
FIGURES 1 and 2 contain many DrawerMicro Oven measurements for
reference when planning the drawer's location.
(6")
Anti-Tip
5"
14
to bottom
Allow " of Anti-Tip
overlap block
14 "
opening
Allow ¾"
overlap.
Allow
Floor must
" support
overlap 100 lbs.
19" to top
of floor
• Check location where the DrawerMicro Oven will be
installed for proper electrical supply.
• Your appliance can be built into a cabinet or wall by
itself or under a gas or electric wall oven.
• Be sure that the clearance of the floor between the
wall oven and the DrawerMicro Oven is a minimum of
2".
• The microwave interior will easily accommodate a 9"
x 13" oblong dish or a bag of microwave popcorn.
block
3 "
15 "
"
FIGURE 2
The DrawerMicro Oven can be installed below any electric
or gas wall Oven.
* Can also be installed using an electrical outlet in an
adjacent cabinet within the area where the provided
electrical cord can reach. Power cord access hole in
cabinet should be a minimum 1
deburred of all sharp edges.
IMPORTANT
electrical outlet to prevent tension.
DO NOT USE AN EXTENSION CORD.
Always check electrical codes for requirements.
E2
4 "
21
1 "
23 "
" diameter hole and
½
Always allow sufficient power cord length to the
"
"
14
15"
auto drawer
opening
23 "
1 "
door thickness