Malfunction Display And Solutions - Electro Depot HIGH ONE DC 7 B W566C Consignes D'utilisation

C
Useful information
NOTE
It is easier to remove lint by moistening it beforehand, for example with a laundry
spray bottle.
Maintenance of the air condenser
- Let the dryer cool down.
- Residual water may run out. Place an absorbent cloth under the maintenance hatch.
1. Unscrew the maintenance hatch.
2. Open the maintenance hatch completely.
3. Screw both blocking levers toward each other.
4. Pull the condenser towards you to remove it.
5. Clean the condenser well and let it drain completely.
14 EN
C
Useful information
6.Clean the seals.
7.Reinsert the condenser using the button.
8.Unscrew both blocking levers.
9.Close the maintenance hatch until it clicks into place. Clean the condenser about every 3
months if used frequently.
Take care not to damage the condenser!
CAUTION
1. Clean with water only, do not use any objects with sharp edges. Never use the
machine without the condenser!
2. During the drying cycle, water may collect between the glass and the seal, this
does not affect the operation of your dryer!

Malfunction display and solutions

Display
The tank is full
The "Full" LED is Problem with the water pump
permanently lit or water level sensor
Temperature sensor
Childproof +9 hours
malfunction
Childproof +6 hours Moisture sensor malfunction
Childproof +3 hours Water heater malfunction
15
Reason Solutions
Empty the tank
Please contact your local
customer service if the
problem persists
EN