Useful Information; Periodical Cleaning And Maintenance - Electro Depot HIGH ONE DC 7 B W566C Consignes D'utilisation

C

Useful information

Periodical cleaning and maintenance

Emptying the water tank
1.Hold the water tank with both hands and pull toward
yourself;
2.Tilt the water tank and pour the condensed water into
a sink;
3.Replace the water tank.
CAUTION
1. Empty the water tank after each use. The programme will pause and the "Full" indicator
will light up if the water tank is full during the drying process. Once the tank is empty, the
dryer can be restarted by pressing the [Start/Pause] button.
2. Do not drink the condensed water.
3. Do not use the dryer without the water tank.
Cleaning the lint hatch
1.Open the hatch.
2.Remove the filter from the hatch.
3.Clean the filter hatch. Remove any lint trapped on the filter hatch.
4. Replace the filter hatch.
Filter hatch
12 EN
C
Useful information
Clean the filter base
1.Open the maintenance grille.
2.Unscrew the two locking levers towards each other.
3.Clean the entire filter base.
4.Insert the filter base again.
5.Screw the two locking levers back on.
6.Close the maintenance hatch until it clicks into place.
Locking lever
NOTE
• Lint accumulated on the filter prevents proper air circulation, which leads to
longer drying times and higher energy consumption;
• Before cleaning, unplug the power cord!
• The dryer should never be operated without its filter!
• Clean the filter after each use to prevent residue from accumulating in the
machine.
Cleaning the thermal condenser
When necessary (approximately every two months), remove lint from the thermal condenser
with a sponge or soft brush.
Please wear gloves during this procedure.
13
Filter base
Maintenance
grille
EN