Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Original Instruction Manual
Dust collection tube must be connected to a vacuum cleaner, which is resistant to dust
generated during processing.
•
Press the dust collection tube so that the hooks can fasten into the guides.
•
Other parts of dust collection tube are as shown as below.
Fitting/Replacing sandpaper
Using hook and loop fastening system.
•
Place the sandpaper in the middle of the sanding disc and press it firmly with your
hand.
•
If the sandpaper is worn in a particular spot, you can remove it, turn it 120° an refit
it or replace it.
Warning! Switch the machine off and unplug the machine before
mounting the accessories.
Operation
• Clamp the work piece. Use a clamping device for small workpieces
• Draw a line to define the direction in which to guide the accessory.
• Firmly hold the machine by the grip
• Setting the speed:
The speed can be sent (from 1 to 6) using the continuous speed adjustment wheel.
The speed will increase according to the number increase and do not adjust the
speed when in actual operation
• Switch on the machine, Push the switch forward to position 1 to switch on the
8
hook
En
01/2017
Publicité
Table des Matières
