Honeywell TP30AWKN Mode D'emploi page 16

USE & OPERATION (CONTINUED)
DRAINING THE WATER (CONTINUED)
2.2 If there are leaks, the Continuous Water Drain Tube and Cap may have loosened and may not be
connected properly. Disconnect, replace and tighten again.
2.3 Position the other end of the
tube is not bent or kinked which might stop the water flow. Make sure the tube is secured over
the drain and will not fall out of place causing unwanted water spillage.
IMPORTANT: Make sure water can flow down the Continuous Water Drain Tube by keeping the tube
angled down and free of bends or kinks.
IMPORTANT: If the unit is placed on uneven ground, or the Drain Tube is installed incorrectly, the
water may fill the water tank and stop running. Please check whether the ground is uneven and
reinstall the Drain Tube.
Continuous Water Drain Tube
EN 15
in the sink or drain. Make sure the