Timer Control; Fan Speed Control; Sleep Mode - Honeywell TP30AWKN Mode D'emploi

USE & OPERATION (CONTINUED)
FUNCTION BUTTONS (CONTINUED)

TIMER CONTROL

The dehumidifier can be set to automatically switch ON or OFF for a selected period of time (between
0.5-24 hour intervals). The Timer hours selection is displayed on the Display Screen.
NOTE: Before setting the Timer control, make sure there is power to the unit.
Auto-Off Timer:
While the unit is running, press
the number of hours (0.5-24 hours) you want the unit to run before it switches off. In 5 seconds
without the operation, the Timer start function, the timer
must be set again after each use.
Auto-On Timer:
When unit is in Standby Mode, press
select the number of hours (0.5-24 hours) until you want the unit to automatically start
running. In 5 seconds without the operation, the Timer start function, the timer
light is illuminated. The previous fan speed and humidity setting will be maintained. The unit
will turn on and continue running until the water tank is full (unless the unit is set up for continuous
draining) or until you switch it off manually. Timer must be set again after each use.
NOTE: To cancel any Timer settings, simply press
disappear.
NOTE: The solid red Power light indicates the unit is on Standby Mode.

FAN SPEED CONTROL

There are two fan speeds - High and Low. When, the
unit is operating on High speed. When the
the unit is operating on Low speed.
FILTER ALERT
When the Filter Alert Light is ON, it is time to clean the filter. Switch the unit OFF and carefully remove
the filter from the unit and clean. Replace the filter, switch on the unit and reactivate the Filter Alert
button by pressing it once.
The Filter Alert Light should not be illuminated until the filter requires cleaning again. The frequency
of filter cleaning depends on room environment conditions. Some rooms may require changing more
frequently than others.

SLEEP MODE

The LED display brightness will be reduced when the unit is in Sleep Mode. Press the
the Sleep Mode. When Sleep Mode is activated the
is a one-minute window period in which you can adjust the settings such as humidity and fan speed.
After one minute has lapsed, the top display will shut off, except the
button to deactivate Sleep Mode.
, the timer indicator light will flash, press
, the timer
again, and the timer
indicator light is off, and the unit is on -
EN 11
indicator light is illuminated. Timer
indicator light will flash, press
indicator light will
indicator light is illuminated, the
indicator light will be illuminated. There
indicator light. Press any
or to select
or to
indicator
to activate