Routine Maintenance; Electric Wire Substitution - Bartscher 703.245 Mode D'emploi

ARMADIO FRIGO
13.
ENG

Routine Maintenance

In order to make ad adequate maintenance of the appliance, the user, the
maintenance man or the non-specialized staff must firstly keep in mind the elementary
safety rules quoted on paragraph n. 3 GENERAL INFORMATION.
Then, it is also compulsory to not remove the safety devices and the protections during
the routine maintenance.
OTHERWISE, THE PRODUCING COMPANY DECLINES ANY RESPONSIBILITY
FOR DAMAGES OR ACCIDENTS RESULTING FROM THE FAILURE TO COMPLY
WITH THE ABOVE-STATED OBLIGATION.
Considered the previous rules, the cleaning of the cooled storage must be done daily,
in order to guarantee the best quality and the perfect hygiene of the treated products.
Use water and non-abrasive cleansing agents. Wash and rinse using a cloth or a
sponge.
N.B. NO SHARP OR ABRASIVE INSTRUMENTS, NO SOLVENTS OR DILUENTS
For a better air circulation, keep clean also the condensing unit (part 19) removing
from its wings dust etc. To reach the condensing unit, you must pull out the plug from
the electrical socket, and unscrew the front panel (part 16) paying attention on not
putting in excessive traction the electrical connections. Use a vacuum cleaner in order
of not having a dispersion of dust. Do not scrape with sharp or abrasive instruments.
At the end, reassemble the front panel closing the fixing screws.
In case of extraordinary maintenance to the refrigerating system, it is possible to
remove the lateral panel, but such operations can be made exclusively by refrigerator
or authorised technicians, and only after having pull out the plug from the electrical
socket.
N.B. Maximum capacity for lever 20 Kgs. each.

13.1 Electric wire substitution

If the electric wire is damaged, the substitution must be done by the producing
company, by its assistance service, or by a qualified engineer. In any case, be sure of
having unplugged before proceeding in such operation.
20