Publicité
Les langues disponibles
Les langues disponibles
KTX-H12 12", KTX-H10 10" Enclosure Link Instruction
1
By hand tighten (2) threaded center alignment
dowels into each enclosure. (4 Total)
3
On the rear of the combined boxes align the rear
linking bracket to sit flush into the recessed area.
5
Place the two steel connection plates into the top
and bottom channels on the rear of the front port
cover.
2
Slide both enclosures together nesting the center
alignment dowels into the opposing enclosure
snugly.
4
Take (8) M5 14mm screws and carefully start
threads by hand tightening the steel plate into
place with the included hex key wrench.
6
Remove the (4) 20mm M5 Port Hex Screws.
(Set them some place safe you will not need them
unless unlinking your enclosures)
3
Publicité
