Note 1: When battery power is sufficient, the light is constantly red ; when the battery is low, the
LED light will start blinking.
Note 2: Remove the battery from the monitor if you do not plan to use it for a prolonged period
of time.
5. Adjust the volume to a comfortable level.
Using AC Power
1. Plug one end of the provided power adapter into a wall outlet and the other end into the
bottom of the monitor. See Fig. 8.
Note: Use the adapter labeled OUTPUT: 6V DC with the monitor.
2. Turn the monitor on. See Fig.8.
3. Adjust the volume to a comfortable level.
Note 1: When charging starts, the "POWER" LED will appear blue . If charging is finished (fully
charged), the "POWER"LED light will turn red.
Note 2: When
the camera and the monitor is linked
the "Link" LED will become red and blinking.
Note 3: No
image would be displayed on the LCD screen if the monitor is
the range (unlink).
2.2 Brightness Setting
Adjust the Brightness selection button
2.3 VOX ( voice-operated transmission) function
1. Press the "VOX" button on the side of the monitor. This will turn off the screen but the "VOX"
LED will remain ON (blue). See Fig 10.
2. When the sound from the camera reaches the set level, the screen will turn on automatically. .
It will turn off again after 30 seconds if no sound is detected.
2.4 Music Function
You can play the music with the camera (three pieces of music).
1. Press the play button
2. When you press the play button again, the music will
3. Pr
ess the next button
Note: If you activate the music function, the music button LED
ON (red).
Troubleshooting
You don't get a signal at all
• Make sure the camera and the monitor are turned on.
• Make sure the power plugs are pushed all the way in.
• If the camera/monitor is powered by batteries, replace all batteries with new ones.
/
, the camera will play music . See Fig 11.
when the music is playing,
, the "Link" LED will become green; otherwise,
to adjust brightness. See Fig. 9.
be paused
. See Fig 11.
the camera
exceeds
will play the next song
will remain
.