Loading The Batteries; Monitor Setup; Loading The Battery - miniland baby 89035 Manuel D'instructions

Loading the Batteries

1. Loosen the screw on the bottom of the camera by using a screw driver.
2. Open the battery compartment cover . See Fig. 3.
3. Insert 4 AAA-size batteries (follow the plus (+) and minus (-) signs inside the
battery compartment). See Fig. 3.
4. Close the battery compartment cover, and make sure it is locked securely.
Note 1: Do not mix old batteries with new ones.
Note 2: Remove the batteries from the camera if you do not plan to use it for a prolonged
period of time.
5. Slide the POWER switch to the ON position. The LED on the camera will light up (red light).
See Fig. 3.
Note: When battery power is sufficient, the light is constantly red;
LED light will start blinking.
Using AC Power
1. Plug one end of the provided power adapter into a wall outlet and the other end into the
bottom of the camera. See Fig. 4.
Note: Use the adapter labeled OUTPUT: 6V DC with the camera.
2. Slide the ON/OFF switch to the ON position. The LED on the camera will light up (red light).
See Fig. 4.
1.2 Fine Tuning
Place the camera in a convenient location, point the lens towards the observation area and
adjust the angle by rotating the lens head. See Fig. 5.
1.3 Night light
Press the night light button, the night light LEDs will remain ON. See Fig. 6
1.4 Night vision
The camera has nine high-intensity LEDs for picking up clear images in the dark.
When the built-in photo sensor detects low ambient light levels, the LEDs will automatically
activate.
2

Monitor setup

2.1 Power supply
The monitor uses 3.7V 1000mAH (Li-ion) battery or the household AC power current.

Loading the Battery

1. Open the battery compartment cover on the rear of the monitor . See Fig. 7.
2. Insert the battery and make sure the polarity is correct. See Fig 7.
3. Close the battery compartment cover, and make sure it is locked securely.
4. Turn the monitor on. See Fig 7.
See Fig. 3.
when the battery is low, the