Meec tools 018625 Mode D'emploi page 24

EN
3. Turn the product upside down, put the refill tube in the refill
valve and press down for 3 to 4 seconds. Repeat 3 times. The
product is filled when gas leaks out from the refill valve.
FIG.
4. Never use an adapter or equivalent on the gas container
refill tube – the valve is designed for direct filling from the
gas container. Adapters are usually intended for filling
lighters
LIGHTING
1. Turn the stop valve 2/3 of a turn anticlockwise. Gas flows out
from the product with a hissing sound.
FIG.
2. Press the lighter button. The flame lights immediately.
FIG.
3. Press the lighter button again if the flame does not light.
If the flame still does not light, check that the adjuster ring
for the air flow is not covering the ventilation hole. Turn the
stop valve to closed position and hold the product so that
you can see into the burner from the front. Press the lighter
button while the flow of gas is turned off. You should see a
spark between the lighter pin and the inside of the burner.
Never press the lighter button when the burner is pointed at
yourself or any flammable material. If a spark is seen, repeat
the lighting process. Open the valve 1/2 or 3/8 of a turn and
press the lighter button.
24
3
4
5