Installation Instructions; On-Off Control - CitrinSolar CS-ZV Manuel

CS-ZV
4

Installation instructions

The installation of the valve must be carried out in accor-
dance with the approved technical regulations. Ensure ex-
cess sealing material, tape etc does not enter the valve body.
In order to avoid blocking of the valve ball, pay attention
to the following advice and avoid all soldering, or welding
processes close to the valve.
flow direction
1 - ball valves
5

On-off control

WARNING! Electric shock!
The red limit switch lead is not insulated
and carries voltage when the valve is in the
open position!
If the actuator is not fused through the
controller connected, there is a risk of elec-
tric shock!
Fuse the operating voltage with an
external pre-fuse of max. 2A!
Ader
Black Control line
If the auxiliary phase L (230 V~) is energised, the
valve opens.
If there is no control signal, the valve is put back to
its initial position (closed).
Brown permanent live L (230 V~)
Blue neutral line N (230V~)
Red limit switch output signal
Note
A cable loop of about 25 cm is required for +/- 90°
manual operation.
CitrinSolar GmbH Energie- u. Umwelttechnik • Böhmerwaldstr. 32 • D-85368 Moosburg • Tel.:+49 (0) 8761/33400 • Fax: +49 (0) 8761/334040
Page 13/48
Important note
In order to attain the maximum operating safe-
ty and reliability, it is recommended to flush the
system and to insert an appropriate strainer (0,65
μm) in front of each valve.
~ 0,65 μm
2 - strainer
3 - EMV 110.. Compact- ball valve
black
control cont.
blue
brown
red