Tyre Check; Head Light Check - Benelli BN600GT Manuel D'utilisateur

EN

TYRE CHECK

Use a gauge to check the pressure.
Pressure should be measured while
tyres are cool.
Tyre pressure
Front tyre:
Back tyre
• Make sure that there are no fragments
of metal, nails or gravel in the tyre
tread. Remove if necessary.
• Check for wear. Replace tyres if the
Front tyre:
2.4 bar Back tyre
2.4 bar
Incorrect pressure, or excessive or ir-
regular wear to tyres will reduce vehicle
stability.
wear is excessive or irregular. The
depth limit for tread is:
1.6 mm
1.6 mm
WEAR LIMIT
IMPORTANT NOTICE:
92

HEAD LIGHT CHECK

With the engine running, check the cor-
rect operation of positioning lights, front
and back, the strong and dipped head-
lights and the numberplate light.
Headlamp adjustment
Sit on the vehicle at a distance of 10
metres from a wall. Switch on the high
beam and measure the maximum height
of the lit area.
• Standard height from ground level:
9/10 total height.
If the values found are not the same
as the standard measurements, go to
a Benelli assistance centre for adjust-
ment.
10 m