Rollei Smartphone Gimbal Traveler Mode D'emploi page 21

Calibration (Initialization)
If the stabilizer shows the following effects, please calibrate it:
The tilt angle is not levelled with the vertical surface.
Under the lock mode the panning anlge is drifting.
Calibration Operation Instruction
1. Turn on the stabilizer and press the mode switch button for about 6
seconds until the M1 & M2 light is constantly turned on.
2. Lay the stabilizer on a static flat surface and make sure that there is no
shaking. The calibration is done if the M1 & M2 light is continuously
flashing for 3 times.
3. Turn the stabilizer off and restart it. If the calibration failed, please
repeat the steps 1 and 2.
Disclaimer
1. Please install and use the product according to the manual.
2. Please use a standard battery charger.
3. Please ensure that the smartphone is well positioned in the gimbal
before turning the device on.
4. Keep the battery/product away from fire and heat sources.
5. Any illegal purpose with this product is prohibited. Users will be
responsible for all behaviour of purchasing and using the product. For
any unknown sources or usage, we will not provide any service.
21