Service; Epa Requirements - JB INDUSTRIES F6-DP Instructions D'utilisation

JB INDUSTRIES
PROBLEM
F6-DP overheats
Recovery process
too slow

SERVICE

The F6-DP uses electrical components recognized by international safety agencies or
components that have been specially designed for this application�
Do not change any of these components, as it could compromise safety� All service
work must be performed at a JB Industries-approved facility to maintain the safety rating
and the warranty�
If defective, do not return F6-DP directly to the factory� For technical assistance or service
information, contact JB Industries or your wholesaler�

EPA REQUIREMENTS

Under Section 608 of the Clean Air Act (40 CFR Part 82), the Environmental Protection Agency
(EPA) has established regulations that cover all aspects of the refrigerant recovery process�
These regulations have established service practices that maximize the recycling of ozone-
depleting compounds during the servicing and disposal of air-conditioning and refrigeration
equipment�
Certification requirements for recovery equipment and technicians have also been
established� The JB Industries F6-DP has been EPA Certified for use by an independent
laboratory�
The EPA has also established Evacuation Requirements for HVAC/R equipment used for
service, to ensure that any release of CFCs or HCFCs to the atmosphere is minimized�
14
F6-DP OPERATING MANUAL
CAUSE
Excessive head pressure, due to:
1. High ambient temperature
2. Restricted discharge hose
3. Air in recovery tank
1. Head pressure is too high
2. System refrigerant is frozen
3. Compressor seals are worn
ACTION
1. Reduce tank temperature
2. Check and clear restriction
3. Bleed air from tank
1. Reduce tank temperature or
change tanks
2. Interrupt process to allow ice to
dissipate
3. Rebuild compressor with
service kit — contact wholesaler
for assistance
TM