Emerson InSinkErator indulge Serie Manuel Du Propriétaire page 9

Please read Troubleshooting Guide and/or visit
www.insinkerator.com before calling AnswerLine
TROUBLESHOOTINg
PROBLEM POSSIBLE CAUSE
Water and steam spits • Unit is boiling.
forcefully from spout
May be normal during initial setup.
without turning on the
dispenser faucet.
Water is not hot. • The unit is unplugged.
• The electric outlet is inoperative.
Water is too hot • Thermostat is not adjusted to
or not hot enough. your needs.
Water comes out the • Outlet tube is blocked.
vent instead of spout.
Water is dripping from • The expansion chamber isn't draining
the spout/vent properly due to low water pressure.
intermittently.
• The spout is blocked.
Water is dripping • Debris in the water line may be
from the spout/vent con- in the faucet valve seat causing a
stantly. slow water leak.
Divided stream. • Debris in the end piece.
Water discoloration/rusty • Corrosion of unit.
appearance.
FILTRATION ISSUES
Water taste or odor. • Filter needs to be flushed out.
• Life of filter has expired.
New filter leaks or • Head and bracket not fully rotated.
doesn't fit. • Filter O-ring breach.
No water flow or • Life of filter has expired.
low water flow.
If you are still experiencing trouble call the AnswerLine
16
®
WHAT TO DO
• Activate faucet lever to release some water from
the tank.
• Adjust water temperature using dial on tank front.
Remember that at higher altitudes, water boils
at lower temperatures.
• Make sure the unit is connected to a properly grounded
electric outlet.
• Make sure the circuit breaker or fuses are
functioning properly.
• Check that the outlet is not switched off.
• Adjust the thermostat slowly, then activate faucet lever for 20
seconds to bring in fresh water to be heated at the new setting.
Allow 5-7 minutes for water to reach new temperature.
• Check that outlet tube is not kinked, twisted or pinched.
• Unscrew spout end piece and clean out any debris.
• Unplug the unit. If the dripping doesn't stop after a few
minutes, check the supply valve to ensure that is fully
open and there are no obstructions in the water line
reducing the pressure below 30 psi (i.e., a poorly mounted
saddle valve, a clogged water filter, or a partially opened
shut-off valve).
• Unscrew spout end piece and clean out any debris.
• Unscrew spout end piece and clean out any debris.
• Activate faucet lever 7-10 times to flush faucet & lines.
• Unscrew spout end piece and clean out any debris.
• Unplug and drain unit as described in the Seasonal
Storage/Drainage Section on page 14 of this manual. If the
water discoloration remains after draining and refilling unit,
discontinue use and contact an authorized InSinkErator
service agent.
• Activate the faucet lever and run until the water is cold.
If there is no change, replace filter cartridge.
• Remove, inspect, reinstall filter cartridge.
• Remove new filter, replace with old filter. Check operation.
If OK, reinstall new filter and recheck operation.
• Replace filter cartridge. See page 14.
1-800-558-5700.
®
Dispensador de agua caliente instantánea
Manual del usuario
Instalación, cuidado y uso
Installation, Care & Use
Installation, soin et utilisation
GN/HC1100
GN/HC2200
GN/HC2215
H/HC3300
CONTEMPORARY
ANTIQUE
TUSCAN
MODERN
SST-FLTR