Mounting Example At Particular Case; Wiring - Optex Smart Line Serie Instructions D'installation

Fix the back box on the pole.
2
Side wall
Distance from the side
wall: at least 1m
M4×20 screw
(with rubber washer)
Pole 43 to 48 mm dia.
(1.69 to 1.89 inch dia.)
Perform the same procedure as 3 to 9 of "3-2 WALL MOUNTING".
3
3-4

MOUNTING EXAMPLE AT PARTICULAR CASE

It is not recommended to be installed the
1
transmitter and the receiver facing each other
through the corner of the cover.
[ Top view ]
Transmitter
3-5

WIRING

Receiver Main unit
Red
Black
Yellow
Orange
Brown
Green
Blue
Purple
Gray
Main unit
Transmitter
Red
Black
Green
Blue
Pole bracket
U-bracket
Detector
No. 1
Receiver
Back box
Battery
Plate
COM
NC Alarm
NO
Low battery
Tamper
Back box
Battery
Plate
Low battery
Note>>
• This section shows for reference as an example of duplicate communication.
• It can usually be omitted because the low battery signal of the transmitter is to be
sent to the receiver through the infrared beam.
EN-9
Detector
No. 2
In doing this installation, the maximum detection
2
range shall be half of the original detection range.
(This is to compensate the attenuation of beam by
the corner of the cover.)
ex) SL-200TNR 60m/200ft.
Wireless
Transmitter
Note>>
• If a wireless transmitter has an N.O.
output, the low battery output nor the
tamper output can not be used.
Wireless
Transmitter
30m/100ft.