Fellowes Levado 1146339 Instructions page 4

STEP 2
Adjust the position of the frame before attaching it to the table
• Using two people, place the table top on the base.
• Check that the table top supports on each side are flush to both ends of the
desktop and align to the predrilled holes on the desktop
• The rear cross channel will be 240mm (9.5") for 800mm (31.5") Depth Tops
from the rear of the table
STEP 3
Clamping base to table
• Slide clamps on each side of the table.
• On each clamp, tighten the (2) thumb
screws until each click.
INSTALL OPTION 2 - HARDWARE
STEP 1
Preparing for installation using two people
• Place table face down on a soft, clean surface.
• Ensure levers on base are in the upright position.
• Fold out legs until they click,
objects clear when lifting legs.
• Lock legs into place by pushing down on levers.
• Optional: If legs need to be folded, ensure lever is in upright position and
power is unplugged. Pull out pin and carefully guide legs to folded position.
• Lift base out of box and place on table.
• The base arrives adjusted for 1600mm (63") wide tables. If your table is
not 1600mm (63") wide you will need to adjust the base width 1219mm –
1829mm (48" – 72"). See step 1B, otherwise move on to step 2.
4
WARNING: Pinch Point! Keep hands and
Rear
240mm (9.5")
Front