Operation - Heathrow Scientific MagFuge Manuel D'instructions

Operation

1. Remove the contents from the package examining them carefully for
breakage, defects or missing parts.
2. Place the product on a clean sturdy, level surface at least 12" (30
cm) away from the edge of the counter and other moving equipment.
Make sure the AC power adapter and cords are clear of hot surfaces
and other hazards. Ensure no person or hazardous substances are
within a 12" (30 cm) zone around the product.
3. Make sure the product has ventilation and is not encased in any
material that will limit airflow. An overheating situation could occur.
4. Position product so that it is easy to disconnect from mains outlet.
5. Verify that the power switch in the back of the unit is in the OFF
position. Plug the DC cord into the rear of the unit and the AC cord
an approved outlet.
ONLY use Heathrow supplied power cord and adapter.
6.
Prior to every use:
— Inspect unit for cracks, missing pieces, and or any damage that would
result in an impaired performance and notify manufacturer BEFORE
use.
— Make sure the power switch on the rear of the unit is set to "O" which
stands for "OFF".
Warning!
This device can be used as either a Centrifuge or Stirrer. User must follow
the proper directions depending on whether the centrifuge mode or the
stirrer mode is selected:
9