Safety Of Others - Black & Decker KS900E Mode D'emploi

•
Keep hands away from cutting area. Never
reach underneath the work piece any
reason. Do not insert fingers or thumb into
the vicinity of the reciprocating blade and
blade clamp. Do not stabilize the saw by
gripping the shoe.
•
Keep blades sharp. Dull or damaged blades
may cause the saw to swerve or stall under
pressure. Always use the appropriate type of
saw blade for the workpiece material and
type of cut.
•
When cutting pipe or conduit, make sure that
they are free from water, electrical wiring,
etc.
•
Do not touch the workpiece or the blade
immediately after operating the tool. They
can become very hot.
•
Be aware of hidden hazards, before cutting
into walls, floors or ceilings, check for the
location of wiring and pipes.
•
The blade will continue to move after
releasing the switch. Always switch the tool
off and wait for the saw blade to come to a
complete standstill before putting the tool
down.
Warning! Contact with, or inhalation of dusts
arising from cutting applications may endanger
the health of the operator and possible
bystanders. Wear a dust mask specifically
designed for protection against dust and fumes
and ensure that persons within or entering the
work area are also protected.
•
The intended use is described in this
instruction manual. The use of any accessory
or attachment or performance of any
operation with this tool other than those
recommended in this instruction manual may
present a risk of personal injury and/or
damage to property.

Safety of others

•
This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless
they have been given supervision or
instruction concerning the use of the
appliance by a person responsible for the
their safety.
•
Children should be supervised to ensure that
they do not play with the appliance.
Vibration
The declared vibration emission values stated in
the technical data and the declaration of
conformity have been measured in accordance
with a standard test method provided by EN
60745 and may be used for comparing one tool
with another. The declared vibration emission
value may also be used in a preliminary
assessment of exposure.
Warning! The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which
the tool is used. The vibration level may increase
above the level stated.
When assessing vibration exposure to determine
safety measures required by 2002/44/EC to
protect persons regularly using power tools in
employment, an estimation of vibration exposure
should consider, the actual conditions of use and
the way the tool is used, including taking account
of all parts of the operating cycle such as the
times when the tool is switched off and when it is
running idle in addition to the trigger time.
Labels on tools
Warning! To reduce the risk of injury,
the user must read the instruction
manual.
ENGLISH
7