HoMedics BUBBLE BLISS Manuel D'instructions page 5

INSTRUCTIONS FOR USE
1. Ensure that the unit is unplugged before filling with water. Fill with water to the max fill line located
on the inside of the tub.
CAUTION: Do not fill water over the max fill line.
NOTE: The footbath will not heat cold water. For a warm water massage, fill the unit with warm water.
2. Plug the unit into a 120-volt household outlet.
3. The footbath comes with 3 interchangeable foot massage attachments (Fig. 3). Place the attachment
that you desire into the center node slot (Fig. 1). Replace unused massage attachments on front of
footbath (Fig. 2).
4. Press power button once to turn on bubbles (Fig. 1).
5. While seated, place your feet in the footbath.
6. Enjoy a deep soothing massage by sliding feet back and forth over the raised nodes on the footbath
floor or over center massage node.
7. When finished, press power
8. To empty: First, unplug the unit. Tip the unit, allowing water to pour out along the rear corner of the
footbath. DO NOT pour water over the power
NOTE: DO NOT hold or carry the unit by the removable splash guard.
CAUTION: To avoid injury and irreparable damage, always remain seated when using this footbath.
Never stand on or in the unit.
CAUTION: THIS UNIT CAN ONLY RUN WITH WATER IN IT. DO NOT USE WITHOUT WATER.
button once.
button (Fig. 1).
5