Sportsstuff Super Big Betty Instructions D'utilisation Et Avertissements page 5

INFLATION
Proper inflation is the key to fully enjoying this product. The cover should be taut with few
wrinkles. When you stand on the tube, it should barely sink.
Your SPORTSSTUFF inflatable is equipped with one or more of the following valve types:
Speed Safety Valve: Pulls out for fast inflation/deflation, then can be pushed in
flush with the tube. Secure the valve by firmly fastening the bottom portion of the
valve into the base. To inflate, open cap or top portion of the valve. Using the hose
from your inflator, inflate through the top opening of the valve.
Stem Valve: Affix the end of your inflator hose into the opening in valve. Make
sure you open the flap inside the opening and inflate until firm. Deflate using your
SPORTSSTUFF pump, or insert a blunt object to open the flap.
MONITORING & MAINTAINING PROPER INFLATION
To prevent serious damage to seams and I-beams, remove some air or move to a shaded area
when exposure to direct sunlight heats up the tube and causes the air inside to expand. Add
some air if exposure to cool air or water lowers the air pressure inside.
KWIK CONNECT TOW SYSTEM
Follow the instructions below to properly attach a tow rope when using this system.
TOW CONNECTION SET-UP:
If your product has this type of system please refer to the diagram below. Loop the top nylon
strap through the bottom loop and pull up tautly on the nylon strap. Affix your rope to the nylon
strap and you will be ready to go.
1
Special Note: The tow system should only be used as shown in this diagram. Towing from the
top or bottom strap alone will cause the tube to function incorrectly and may risk damage to the
cover or tube. Damaged caused by improper use will void your warranty.
GYRO:
One end of the swivel is already attached to the Gyro's tow system.
Attach your tow rope to the other end of the swivel.
1
2 3
2