WEGOMA Porta Master PM3000 Mode D'emploi page 40

Porta Master PM3000
Place the guide plate 6 (Fig.1) onto the work piece and place the pressure roll 9 close to the work piece without
touching it. Hold the machine tight to the bearing plate with the "right hand". Press the switch (8) at the hand
grip. The feed is started. With the left hand lead the edge through the two guides 14 until the transport roll 13
is reached. The edge is transported forward automatically now. Wait for around 2 seconds till the band has
reached the pressure roll and press the nip roll against the work piece. The movement of the pressure roll 9
automatically moves the machine ahead with a speed of 3.8 m/min. Pushing the machine forward would lead
to non uniform speed. At the end of the band make sure that the machine is led further uniformly in height and
direction until the protruding band is led out of the nip roll.
Abb1
6
9
8
13
14
40