Keep In Mind Before Using The Edge Banding Device - WEGOMA Porta Master PM3000 Mode D'emploi

Porta Master PM3000
4.2

Keep in mind before using the edge banding device

ATTENTION!
PLEASE OBSERVE BEFORE FIRST USAGE OF YOUR EDGE BANDING DEVICE. The
following hot melt adhesives can be used to glue edges: WEGOMA SKG 170, Kleiberit:EVA-
SK788, Dorus: KS 217, Jowat: 280.40
Please observe the instructions of the manufactures of the glue.
• Machine can crash or fall down.
• As a result persons might get hurt.
• Place device so that it cannot crash or fall
• Hold device with both hands at the handholds when you glue edges
• Surfaces can become hot due to hot glue.
• Be careful when handling hot parts.
Please keep in mind that when you switch on the device the feed
switch (A) has to be in position "off"
The glue adjusting screw (B) and the lid of the glue reservoir (C)
will stick after the machine has cooled down. Do not try to adjust
them or to remove the lid before you have re-heated the machine.
Should an edge jam, you always have to remove it into transport
direction. Never pull back the edge, as otherwise the pressure and
transport roller can get dirty with glue and get sticky. (Fig. 4)
37